Best

IQ6

• BEST® brand compatibility – designed specifically to pair with compatible BEST® kitchen range hoods for a matched fit and intended performance.

• iQ Blower System™ (iQ6) – intelligent blower platform designed to help the hood achieve its rated airflow by compensating for typical ductwork resistance.

• Guaranteed Performance Technology – calibration-based performance approach intended to optimize delivered airflow after installation.

• iQ6 600 CFM internal blower – provides strong ventilation capacity to help remove smoke, odors, heat, and airborne grease produced during cooking.

• Internal (in-hood) blower design – mounts inside the hood to keep the ventilation system compact and integrated.

• Single-wheel blower construction – single-wheel blower design intended for efficient air movement in compatible hood systems.

• Rough-in kit included – includes the rough-in/connection components needed to mount and integrate the blower with the hood.

• 8-inch round damper/adapter included – helps connect to standard 8" round ducting and supports proper exhaust direction control.

• Uses 8-inch round duct – supports higher airflow with reduced restriction compared with smaller duct sizes.

• Vertical or horizontal ducting support (hood-dependent) – works with compatible hood configurations that allow vertical (up) or horizontal (rear) exhaust routing.

• Calibration button / calibration control – initiates an automated calibration cycle to verify airflow and tune blower operation to the installed duct setup.

• Calibration status indicator – provides visual feedback (successful calibration vs. restriction detected) to help confirm proper installation.

• Restriction detection & compensation – if duct restriction is too high to reach nominal airflow, the system indicates the issue and can automatically run at maximum achievable output.

• Reset/clear calibration memory – allows clearing stored calibration data and re-running calibration after ductwork improvements.

• Backdraft damper support – helps reduce unwanted outside air from flowing back into the home when the blower is off (via included damper/adapter).

• 120V power requirement – designed for standard residential electrical supply.

• Motor thermal overload protection – built-in protection helps prevent motor damage by shutting down if overheating occurs and restarting after cooling.

• General ventilation use – intended for everyday kitchen ventilation (not for exhausting hazardous or explosive materials/vapors).

• Installer-friendly wiring compartment – structured wiring connection area intended to simplify safe electrical hookup during installation.

• Designed for ducted exhaust to outdoors – intended to vent air to the exterior for effective removal of cooking byproducts (rather than into enclosed spaces).

• Durable, professional-style ventilation support – built to meet the demands of higher-output residential cooking setups where dependable airflow is important.